General Category > General Discussion

Vicmarc VL200

(1/3) > >>

ru55ell1:
I was very excited when I treated myself to a (second hand) Vicmarc VL200 in December.

I got it in place in my shed in January and found that it was "unstable" when turning pieces (mostly bigger bowl roughings).

Various people put this down to the wooden floor in the shed and I got an engineering friend to "Clock" the Spindle which seemed OK (not under load)

I have since on a number of occasions tried to rough out some big pieces and when turning them (even when they get a bit more balanced) the tool is battered in my hands and the outcome is a roughed out bowl that is not circular. I have tried taking fine cuts which dont put the piece under a great load and this is better but not satisfactory.

Does anyone know if there are any service agents in the North or NorthWest or UK for Vicmarc before I email Austrailia.

My freind has got a VL300 and I have used that in the past to turn some pretty big bowls without this problem.

I do know that the Vicmarc agent is in Ullapool but I couldnt raise them, so thought I would try the collective knowledge of this forum.

I'm a tad miffed and am considering going back to my Axminster M950 and was ripping my hair out when Woody's Maxi sold before I saw it.

Please post if you can help

Regards Russell

Bryan Milham:
I'm not saying this is the answer but it might bear closer examination.

I have a friend with the V175. His headstock bearings went with similar effect.

A pain to replace but they are Car Wheel Bearings from the Aus Holden (part of the GM group) so probably fairly standard availability.

davidbrac:
are you able to show a photo of the lathe as vicmarc have changed the base a few times over the year, and what did you do about the wooden floor? also is it a vl200 short or long bed? as the shorts can be more unstable than the long.

My feeling it is to do with seating the base rather than the bearing

ru55ell1:
Thanks for responses

Put 22mm chipboard underneath lathe (Need to take floor out when weather better and put concrete base in )

Its a VL200 Shortbed

Will try to get a pic on tomorrow as I have to go out in 10 mins :-)

Terry Miller:
Russell. Try putting a big blank into your chuck and then get hold of the blank with both hands and try and lift it. If you feel any movement no matter how slight then suspect your bearings.This is a way of checking to see if there is play in the bearings. Another check is to get a long screwdriver and place the tip on the headstock near where the shaft comes through and then with the lathe running put you ear to the top of the screwdriver like a doctor with a stethoscope and listen. If you hear any abnormal noises such  as clicking or grinding noises then your bearings are on the way out.
If after these checks you suspect the bearings any local engineering company should be able to change them as they will be available from a bearing stockist.

Hope this helps.

Regards

Terry.

Navigation

[0] Message Index

[#] Next page