General Category > General Discussion

Pricing

<< < (3/3)

thebowlerhattedturner:
Point taken, are we too fussy for our own good? I remember teaching someone how to hollow out through a small(ish) hole and how to deal with the sanding. He said what was the point of sanding when no-one can see inside. I cringed and said that "I" would know, his answer was "so what". Perhaps we are too fussy but in the end you have to be the one to satisfy as far as quality is concerned. Imagine if someone paid a lot of money for a hollow form and dropped it and the insides were as rough as old boots, the thought of breaking it in the first place is bad enough but to see any part of it badly finished doesn't bear thinking about. :o
 Regards
John

Navigation

[0] Message Index

[*] Previous page