General Category > General Discussion
3 phase motor help
Bryan Milham:
Contact Hughie (of this forum).
He has built (and builds) big Bowl lathes - He'll help you out with all the ideas you'll need to start you off and then guide you.
BarryMobbs:
Hello Dan,
If you are fortunate enough to have a three phase supply you have no problem.
I would suggest you use an inverter drive which will give you a wide speed range.
The motor will only produce 4kW if you load it that much, for most work the power consumption will be much lower.
Regards, Barry
Navigation
[0] Message Index
[*] Previous page
Go to full version