General Category > General Discussion

JSP vs Trend Airshield

(1/2) > >>

yew turn:
I currently have a JSP Aircap (the older model with the power pack on a separate cable as opposed to the power pack built into the helmet), it has only done about 30 hours work and already the motor has started to fail, the supplier has agreed to give me a full refund. I am now in two minds whether to replace it with either the newer version of the JSP Aircap or the Trend Airpro.  Has anyone  have any thoughts on which is the better of the two. Have any of you had problems with your JSP Aircap?  As this is my only precaution against dust in the workshop would I be better off not replacing the airshield and using some other type of dust extraction?
I would very much appreciate your comments.

Tim Pettigrew:
Hi Bill - Here are a few options which I have been exploring which may be useful?
I have a Trend Airshield and have also tried the JSP and although both are great at what they do, I find them cumbersome and also expensive to maintain as regards batteries and filters etc.

At the simplest level you could try the Dust Bee Gone available from many outlets including Turners Retreat.  This is a simple but ingenious washable face mask (designed for woodturners) as recommended by my woodturning tutor.

However, I am currently using a 3M™ 7500 Series Premium Comfort Half Mask which is re-usable and for which there is a range of filters including vapours and gases (useful for vapours produced by Pyrography?), as well (of course) as dust.  The mask is re-usable and replacement filters are relatively cheap.  The mask itself is cheap (especially on ebay) and uses a simple exhalation valve system (no electric fans involved).  This is working well for me.

More info HERE

3M also do a full face version 3M™ 6000 & 7000 Series Full Face Masks - using the same filter system (no fans).  I haven't tried this, going for the simpler (and cheaper!) half mask system which fits OK underneath my head visor.

More info HERE

3M also do a fan powered helmet which I haven't investigated (as the Trend & JSP are probably cheaper?).  However, just for completeness, info on these 3M powered respirators are available  HERE.

Hope this helps?

Tim

Les Symonds:
Hi Tim...that was a very timely response....I was about to add a thread about the 'Dust be Gone' mask. I spotted this item on the Turners' Retreat website and wondered how effective it is....in the light of the rather complex masks that are available, this simple little mask seems almost too good tom be true. Has anyone had experience of using one?

p.s. ...  sorry, yew-turn, for hijacking your thread, but this does have relevance!

Les

Paul Hannaby:
A few things to bear in mind -

Not all respirator masks provide impact protection. Unless it did I personally don't see the point in using one. The recent injury to someone wearing a respirator is probably a good example why adequate impact protection is also vital.

The Dust be gone masks are described by their manufacturer as "nuisance" dust masks and don't provide filtration below 3 microns. They are not approved in the US where they are made and don't appear to have any UK or European standard compliance either.

yew turn:
Hi Tim, thank you for the info regarding the dust masks, I certainly need to take a closer look at the options available. The problem being the more you look the more confused you get :-\

No problem Les, no offence taken.

Thank you Paul for your comments.

Navigation

[0] Message Index

[#] Next page