Hi,
The method I have used is by using T joints
of 1 inch waste pipe held in place by drilling
(I forget what size) for short lengths of the
waste pipe sticking out onto which the T joint
is pushed. I've tried to keep everything tight so
that I did'nt have to use glue. It's not appropriate
for big chisels that won't go through the T joint
but ok for most.
It cost quite a lot for the T's and, because I
have'nt glued the joint to the pipe, they are
prone to leaning. When I find a more appropriate
site for them, I'll get the glue out. Am I happy
with it...
...I think it's ok but not more than that
but I offer it up as an idea.
Although away from the subject of tool holding,
I wonder if people knew that the 'take-away food'
containers do a wonderful balancing act on their side....
I don't know what I'd do without them...
Best wishes - Jim