General Category > General Discussion
Heating /Ventilating a Shed workshop
Bill21:
--- Quote from: fuzzyturns on May 06, 2020, 10:32:25 AM ---I use a oil filled electric radiator, which is set on a minimal setting during winter to prevent anything from freezing (it keeps the shop at around 5 degrees Celsius) and a small fan heater to get the temperature up quickly if I need to. If your fan heater is blowing the dust everywhere then you have too much dust in your workshop (and that is a health hazard in itself).
--- End quote ---
Yes I have exactly the same setup but don’t often use the radiator. I don’t get any dust blown about by the fan heater either. I use a shop vac when sanding and also have an AC400 installed. If I do notice an excess of dust I put the AC400 on timer for an hour or so after I’ve finished working in there and then using the output side of my shop vac I blow all the surfaces clear quickly then go indoors to let the AC400 deal with it.
Navigation
[0] Message Index
[*] Previous page
Go to full version