General Category > General Discussion
Gouge profile set
Woodcrafts:
--- Quote from: iantivenan on May 05, 2020, 07:03:43 AM ---Hi.
I've been trying to obtain a gouge sharpening profile set made by henry taylor. I've tried all the stockists listed but they just say non available.
Does anyone know where I could purchase a set for my workshop.
Thanks Ian.
--- End quote ---
Hi Ian, not sure if you got my PM I sent this morning but I found the set I was thinking of and I am fairly sure these are what you are looking for. Toolpost (Didcot) have them on their website but don't have them in stock. If you are interested in buying my spare set, send me a message and we can sort out how to get them to you. I don't advise posting your address on here.
Regards,
Paul Bellamy
Woodcrafts:
Hi Ian, I noticed you said you wanted them for teachiing. You may find this document useful as it explains how they are used.
https://www.woodturnerscatalog.com/docs/profile_pro.pdf
The jig shown is a Woodcut Trugrind, which I use on my grinders, but the setup will be the same for any jig that allows the toolholder leg angle to be adjusted. Hope that helps.
The document may also be of interest to others who have responded to your post.
Regards,
Paul Bellamy
Navigation
[0] Message Index
[*] Previous page
Go to full version