General Category > General Discussion

How do you make 'spiral' cut grooves in a vessel?

<< < (2/3) > >>

BrianH:
Hi Malcy
The name sounds kind of Scots but if you would like to share your location you just might find you are not quite so lonely after all........
All the best
Brian

Bryan Milham:

--- Quote from: malcy on June 03, 2012, 09:30:06 PM ---I'll post some pictures at some point, when I've finished the segmented bowls I'm making at the moment.

--- End quote ---

Segmented and you asked about Spiral Cuts - that's gonna be some bowl!

malcy:
BrianH. You're right. My name is Scottish as I had a father from Aberdeen, but I actually live in Swansea, in South Wales. Any other turners in Swansea?

GwilymF:
Hi Malcy,  I live in Llanelli where there is quite a good woodworking club that meets every Wednesday night.
Gwilym

malcy:
Thanks Gwylm. I do have a regular prior committment on Wednesdays, unfortunately, but I might pop over one Wedneday. Thanks. Malcolm.

Navigation

[0] Message Index

[#] Next page

[*] Previous page