General Category > General Discussion

versa chuck model T

(1/1)

Peterch:
Hi
I am after a chuck and have seen a versa chuck (model T) advertised.
As I am on a budget would this be a suitable starting place?  I am wanting to turn small bowls etc at the moment
Any other suggestions
TIA
Peter

Bill21:
Unless it comes with a variety of accessory jaws check that they are still available for that model. Not being able to get the jaws you need later on might be an issue for you.

Wood spinner:
Best bet is to save up and buy a current model chuck , What spindle thread is your lathe ?

Peterch:
hi wood spinner 

Its a 3/4 16tpi

Peter

Wood spinner:
https://www.ebay.co.uk/itm/Vicmarc-VM100-Chuck-Wood-Lathe-With-Extra-Jaws-Woodturning-3-4-x-16tpi-spindle/224237048684?hash=item343591d36c:g:H0MAAOSwNNFfsrWe

Navigation

[0] Message Index