General Category > General Discussion

Vicmarc VM120 Jaw Screw size?

(1/3) > >>

As:
Hello everybody,

Greetings :)
This is my first message, so here goes.
I have a Vicmarc VM120, it's my only chuck. I went to change the jaws and one of the screws was tight and I've messed up the hex hole.
I've looked up some ways to sort it out and will get round to that in time.
When that time comes I am going to want at least 1 new screw. I've tried looking up what size screw but found no conclusive details.
Simon Hope has them for sale at about £10 for 8, but I read somewhere about buying lots more for much cheaper.
I would like to hear your opinion on what course might be a good one to take.

Cheers,

As

Valkrider:
A Google search shows them to be M6x12 you should be able to get some from Amazon / eBay or a local supplier.

As:
Thanks, ordered a pack of 20.
Cheers

Bill21:
Sometimes chuck screws don’t have normal countersunk heads. The ones on the Simon Hope site look fairly standard though so you should be ok.  ;) Maybe let us know when you get them as it may help someone else.

As:
I purchased A pack of 20 M6x12mm from ebay for £2.12. https://www.ebay.co.uk/itm/284006064396?var=585472467059
They seem to fit well, and tighten and loosen well too.
Cheers

Navigation

[0] Message Index

[#] Next page