General Category > For Sale / Wanted

Super Precision chuck for sale

<< < (3/4) > >>

Bill21:
Indexing on back plates seems to be a wood turning thing. I don’t think I’ve ever seen one on a Chuck intended for engineering use.

David Buskell:
Thought you might like to see this reply from Axminster:


"Hi David
The Axminster Super precision chuck were Bison chucks from Toolmex and had an Axminster circular sticker where the Bison one is in the picture.  It may be that the poolwood one was labeled as a Bison chuck or may be an early one, unfortunately I wouldn't have any details for anything older than about 20 years. Later chucks were made for us in China. The backplates were made here in Axminster but are no longer made so they are only really suitable for whatever spindle thread you have in the backplates.

Kind regards

Darren
Specialist After Sales"

This confirms the information from the man at Bison.

I guess then the proper  description of the chucks is "Axminster (for the back plates)/Bison (for the chuck) Super Precision"

I have 3 off of these Axminster/Bison chuck available, all with carrier jaws and either C jaws or O'Donnell jaws. Back plates are threaded M33 but I do have a 1" x 8tpi I can swap onto the chuck.

David Buskell:
Price reduction:

Chucks are now £100 but only have them with C jaws left.

Can still provide a 1" x 8 backplate instead of M33 if required.

Thanks

turningal:
Hi David
Do you still have the chuck for sale?
Do you know if backplates are available, I have 11/4”x 8 thread?

David Buskell:
Hi, Apologies for the delay in replying- only just back from short break

Both chucks are now sold I'm afraid.

Navigation

[0] Message Index

[#] Next page

[*] Previous page