General Category > General Discussion
What are these for?
Thomas Lawson:
I recently bought a wood lathe and it came with several of these (photos attached)
They look a bit like small faceplates but the screw holes are countersunk on the wrong side and the bores are not threaded and come in different sizes.
Bill21:
I must admit I’ve not seen anything like these before, I too wonder what they’re for.
BrianH:
I had something very similar screwed into the deck of a yacht to support handrail stantions ( are they made of stainless! I wonder?) my guess is that they have been mistaken for faceplates but are actually nothing to do with woodywork.
Brian
otterbank:
Some face plates did have counter sunk holes on the blank side to allow for any swelling in the wood from the screws used to fix the face plate.
Not sure if those are face plates all the same.
Michael
Thomas Lawson:
--- Quote from: BrianH on August 01, 2023, 04:54:41 PM ---I had something very similar screwed into the deck of a yacht to support handrail stantions ( are they made of stainless! I wonder?) my guess is that they have been mistaken for faceplates but are actually nothing to do with woodywork.
Brian
--- End quote ---
No, not stainless. Yes, could just have been mistaken for face plates I guess
Navigation
[0] Message Index
[#] Next page
Go to full version