General Category > General Discussion

Lathe wheel system

<< < (2/2)

Brian Hensby:

--- Quote from: Tim Pettigrew on December 16, 2012, 09:26:22 PM ---Hi Brian

I know someone who has successfully used THIS SYSTEM on their Killinger lathe.

Any good?

Tim

--- End quote ---

Thanks Tim this is a useful piece of information i have contacted Footmaster directly. Regards Brian H.

Eric Harvey:
If you contact Jon Warwicker at the Fairlop club in Barkingside,he might be able to help out,as he made all their lathe wheel systems from scratch using angle iron and bought in braked wheels from Axminster,just a thought if you know a welder,regards,

Eric.

David Buskell:
Brian,

You could also have a chat to Kent Branch who have a good system for their lathe - we used the same one for our Wivamac.

Another alternative we looked at was the use of caravan wheels - lots about and easy to fix.

David

Navigation

[0] Message Index

[*] Previous page