General Category > General Discussion
MT1 or MT2?
arcos:
I am trying to discover what my lathe uses so that I can get hold of a pen mandrel.
I have measured the bottom of the centre and it comes in at round 10mm I m GUESSING that this makes it an MT1
Would appreciate confirmation please. :-[
Bryan Milham:
Have you got a photo of your existing Live Centre or anything else that plugs into the Tail Stock?
arcos:
I do now ;)
woodndesign:
From your past post as to the make, if we're right on the model, it looks like Nutool or Clarke ... http://www.sitebox.ltd.uk/clarke-cwl12d-wood-lathe-oclarke_6500680 ... as the thread is 3/4" and should it be the same with your's it's likely to be #1 at that small size.
Cheers David
Richard Stapley:
According to this
http://www.laymar-crafts.co.uk/info5.htm
You have a 1MT
Richard
Navigation
[0] Message Index
[#] Next page
Go to full version