General Category > General Discussion
Lathe Height
Paul Disdle:
I guess this is going to be a personal preference thing, but i there any rough suggestion to lathe height and body. Like lathe bed parallel to hips or something
Thanks
Paul
Bryan Milham:
Headstock centerline level with your elbow, plus or minus a bit.
Les Symonds:
--- Quote from: dr4g0nfly on April 04, 2013, 07:35:08 PM ---Headstock centerline level with your elbow, plus or minus a bit.
--- End quote ---
Is that before or after you build a 300mm thick layer of shavings under your feet? ;)
Bryan Milham:
--- Quote from: gwyntog on April 04, 2013, 09:01:35 PM ---Is that before or after you build a 300mm thick layer of shavings under your feet? ;)
--- End quote ---
You been peeking in my workshop?
bodrighywood:
Before the shavings LOL. My lathes have approx 150mm difference in height so I have a platform to stand on for one as the work bench is built for flat work. I also have another platform for when I am teaching as being 6'4" most students tend to be a bit shorter.
Pete
Navigation
[0] Message Index
[#] Next page
Go to full version