General Category > General Discussion
A very near miss
(1/1)
Dave Atkinson:
Hi all
Just seen this "you tube" post. Just shows what happens when you don't check - he's a lucky guy.
http://www.youtube.com/watch?v=NG9vXLOtCaI&feature=related
Cheers Dave
Andy Coates:
That was frightening!
It didn't look like the glue joints were up to much either.
A good lesson for turning the lathe to its slowest setting after you finish a job.
Bryan Milham:
Clean shreddies please!
Derek:
At least he had the common sense to satand to ome side. It looked like he started it and just wound it up
BrianH:
I think Andy knocked the nail on the head. If you look closely you can see that the glue lines, which SHOULD be stronger than the wood, have lost interest in procedings at every joint. That's where matey's problems lie, the lathe only supplied the centrifugals.
Brian
Navigation
[0] Message Index
Go to full version