General Category > General Discussion
how far do you grind your tools down???
seventhdevil:
my most used are getting very low at the moment and i do have replacements but it got me thinking just how far do you let yours go down to?
for reference the bowl gouge is a 5/8" bar.
Bryan Milham:
If I can grind an edge and use it safely, it's still a viable tool.
bodrighywood:
Same as Bryan. Comes a point where I can't access the wheel to grind an edge. Then time to strip and reuse the handle.
Pete
Derek:
As above even short tools have there uses where longer tools will not do.
Wood spinner:
I would have binned them by now , Hardly any reach over the tool test
Navigation
[0] Message Index
[#] Next page
Go to full version