General Category > General Discussion
Chuck jaws sizing jig
simon:
Folks,
Fed up today of keep measuring spigots etc for chuck jaws.
20 mins, aluminium door push plate, stamps and centre punch and I’ll never have to get a rule out again to set my dividers.
(Btw - amazing how close some of the jaw sets are when you set them out like this in one place)
Simon
Sandy:
Good idea, but be careful not to knock it into the shavings, a magnet won't find it :).
Bill21:
Looks similar to a speed sizer.
https://www.axminstertools.com/axminster-woodturning-speed-sizer-106795
simon:
--- Quote from: Bill21 on February 06, 2021, 09:43:32 PM ---Looks similar to a speed sizer.
--- End quote ---
There goes my chance at patent / marketing idea! Yes, is similar, not quite as CNC perfect but £20 cheaper I guess!
simon:
--- Quote from: Sandy on February 06, 2021, 07:28:37 PM ---Good idea, but be careful not to knock it into the shavings, a magnet won't find it :).
--- End quote ---
Just bonding it onto piece thin ply then it will be mounted onto front of lathe bed for easy use (and so I know where it is and don’t lose it!)
Navigation
[0] Message Index
[#] Next page
Go to full version