General Category > General Discussion
Teknatool Chuck
(1/1)
burywoodturners:
Like Dave in his post, I have a donation to our club
We have a Tekntool Super Nova 2 Chuck without an insert. On checking we we found that the insert thread was 1/1/4" but with a left hand thread. It is an old chuck but never used-unsurprisingly!
Any suggestions or offers, we have tried the UK dealers, and they cannot help
Ron
Bryan Milham:
I acquired one of these chuck with the same thread when I bought out a deceased turners workshop.
It took a while to work out what the thread was, so well done on getting that far. It is an American thread, there are users of American lathes in the UK.
What I did was advertise it on a well known internet auction site, it found a new owner quite readily.
burywoodturners:
Thanks, that was the plan! I now have some useful info for the ad.
Ron
Navigation
[0] Message Index
Go to full version