General Category > General Discussion

Draper AWL40 combination chuck

(1/2) > >>

Stormin:
Does anyone have instructions for assembly and use of this chuck?
I’d appreciate a scan/photographs

Twisted Trees:
Didn't even know Draper did a woodturning chuck, there is a good chance it is just a badged generic chuck, if you can post a picture of it someone may recognise it under a different label and have info on it under that name.

Stormin:
Ah, they did.
You may be right that it was made by A N Other,
It has 3 part jaws, not the now usual 4
Any ideas?

David Buskell:
Stormin,
Have you called Draper? They may have what you are looking for in their library. Their website has all the contact numbers

bodrighywood:
3 part jaw chucks are usually for metal lathes not wood?

Pete

Navigation

[0] Message Index

[#] Next page