General Category > General Discussion
Arundel K450 bearings
Bill21:
It’s not unusual for pulleys to be held in with two grub screws, one on top of the other.
Dancie:
Hello, I think, Stiles and Bates will service headstock - I'm sure I read it somewhere but annoyingly I cant find it to send you the link.
Wood spinner:
Or any engineering company
Parisi:
Thanks for all the good advice. I'll get on it and hopefully I'll be back turning before too long...
Roger Groom:
I found a site on tintoretto which sells this manual www.store.lathes.co.uk priced at £29. I used to have one of these until last year and did change the bearings on it. Unfortunately I can't remember how. I think the shift comes out the front end and I seem to remember I had to take the back of the headstock to do it. I will contact the person I sold it to, as I gave her the manual with the lathe. It's a super little lathe though so worth doing.
Roger G
Navigation
[0] Message Index
[*] Previous page
Go to full version