General Category > General Discussion
Woodcut bowl saver Max3 - require dimensions of missing part
Dave Brookes:
Lumsdep,
Do you have a piece of nylon to use? I may have a piece about 31mm dia at the length you need, or even a piece of ptfe.
Let me know although I won’t be able to send anything until next week.
Dave
Bill21:
--- Quote from: Mike Amphlett on March 18, 2024, 11:39:57 AM ---Lumsdep,Paul's photo looks like it was 3d printed, so you might be able to get one made for you.
Mike
--- End quote ---
I doubt it. It’s a simple turning job. Hard to tell but it could be Acetal or Nylon? If I were making a replacement I’d use Ertalyte TX or perhaps one of the lubricated Nylons like Nyloil or Ertalon.
Navigation
[0] Message Index
[*] Previous page
Go to full version